These are from the graphic designer,

That last one looks more like Christmas tree balls than balloons Graham lol.

Still prefer the round one with the balloon dog in the middle would make a good pin badge, it works in most colours.

Some more ideas, well the same but made up from latex,

If we get the graphic designer to put "The Balloon Artistes Guild" around the outside in yellow? Maybe.

It was difficult getting pictures due to all the static,

Last one for the time being.

Changed the outside so it was two/thirds red and not half and half like before, I like the look of the last one at the angle.

Myself I like this one best.
I do think a more modern font would be better but it is clean not to childish and if it is on a t shirt ext it is obvious what it is.

Another idea but with wrong spelling.

I like it but but is it practical as to have it printed or embroidered would be expensive. It has a lot of colours/variation in colour.

Maybe we put the wording inside the original one Rob made up on the black background with two outer balloons in red and yellow and on the balloons we have,
"We Care, Together We Share"

or perhaps we could have just ends of 350's protruding into the badge centre instead of the round balloons with just two colours alternating red and blue.

A few more,

I have had a few works in progress done for the design, anyone got any thoughts?
We might just go with the original but I though it might be worth a play to see if we end up with something nicer.

My favourite is the one with just the bigger dog in the centre. (number 7)

However I would want the lettering in bold and black, and perhaps without the "the"?

Also I like the red and blue combo of colours (number 5), rather than red and orange for the outside.

Well those are my thoughts!