This month's model of the Month will be Santa (Father Christmas)
You can just draw the belt and buckle on to make it just a 3 balloon design.

If you do use the design and would like to contribute a little to keeping the forum up and running then I have signed
up to "Buy Me A Coffee" where you can purchase a coffee or two. It would be appreciated.....Thank You XXxx

https://www.buymeacoffee.com/myballoonart

Here we go with the instructions for making the Santa.

Inflate the 350 red leaving 6 fingers un-inflated.
Make four 5 finger bubbles and securely wrap the knot of the balloon around twice to secure tightly.
Then make a 6 finger bubble to the lower middle section of the four 5 finger bubbles.

Then make two 2 finger bubbles for the eyes and attach around the pinch twist.
Make another 4 finger bubble and another 2 finger pinch twist for the other ear.

Attach the knot of the balloon to this second pinch twist.
Slide the Blush balloon down over the end of the Red 350.

Inflate the White 260 and leave 6 fingers un-inflated.

Attach the White balloon to the right pinch twist as you look at Santa’s face.
What side you attach the White balloon will determine which side Santa’s hat falls to at the end.

Make a 4 finger bubble and attach around the pinch twist under the eyes.
You then need another 4 finger bubble to the other side of his face and wrap into the pinch twist for the other ear.

You then need a 7 finger bubble for the front top section of Santa’s head/hat and attach to the other ear pinch twist.
Push Santa's eyes out the way while you do this. We will push his eyes back into place later.

Make an 8 finger bubble for the loop that the end of the Red 350 sits into and deflate the rest of the White 260.
Wrap the White 260 around the 3 finger bubble and tie into the ear pinch twist.

If you push the two Blush 4 finger cheek bubbles forward the eyes will sit snugly under the White top section of Santa's head/hat.

If you need to work quickly you could just draw his belt onto his tummy.
I have included a Black 350 and a 260 Gold chrome so you can make the belt.
Make a 2.5 finger bubble and then split this in half and make two even pinch twists.

Push one end of the 350 through the centre of the two 6 finger bubbles for Santa’s body and tie to one side.
Then when you push the knot in between the 6 finger bubbles and the buckle to the centre the knot will be hidden up.

To finish add the Blush 2 finger bubble for Santa's nose to the pinch twist below Santa’s
eyes and push the small pinch twist behind the two White 4 finger bubbles.

Add the artwork and there is Santa completed.
I do use a White Edding pen for Santa’s eyebrows.

I also did try to make Santa’s eyes from the White 260 but preferred the look of the Blush for the eyes.
Please try the White as you may prefer that look.

Hope Santa is of use during the holiday season.