Uncategorized Boards > Model Of The Month

July Model of the Month (Whale)

(1/3) > >>

Graham Lee:
This months model of the month is the line work Whale. I did post a Whale tutorial onto BalloonTube
but that was one with a few more balloon in the design. This is the link if you wanted to view that one,
https://www.youtube.com/watch?v=Dz_estVSutk

This is a 4 balloon line work design Whale,
this is the complimentary pack that people will receive with their orders this month.

Graham Lee:
Pre stretch the 260 Black before you inflate as you do need to use a lot of this balloon.
Inflate the first 260 Black leaving between 4/5 fingers un-inflated.
Make two 2 finger pinch twists followed by a 9 finger bubble.
Then twist another 9 finger bubble and twist into the two pinch twists.

Graham Lee:
Then inflate the Ivory Silk 260, you can use White but I prefer the look of the Ivory.
Leave 5 fingers un-inflated and attach the balloon to the two pinch twists.
Make a 9 finger bubble and twist this in between the two Black 9 finger bubbles.
Then make another 9 finger bubble back to the two pinch twists.

On the black balloon you now need a 6 finger bubble and a 1 finger pinch twist.
One of the eyes will attach to this pinch twist later.

Graham Lee:
You then need a 9 finger bubble and another 1 finger pinch twist for the other eye to fit to later.
Then make the last 6 finger bubble and twist this into the two black pinch twists.
The last sequence of bubbles should sit snugly around the 9 finger centre bubbles of the Whale.

For the tail of the Whale inflate the 260 black and leave 5 fingers un-inflated,
make two 2 finger pinch twists.

Graham Lee:
You then need a 6 finger bubble followed by a 4 finger bubble and then a 2 finger pinch twist.

Then make a 2 finger bubble and twist this into the two pinch twists that you started with.

You then need a 6 finger bubble and a 4 finger bubble for the other side of the tail which
is twisted into the single pinch twist.

Navigation

[0] Message Index

[#] Next page